Accelerator Pedal: Installation: Notes

WARNING: This page is about a different car, the 2006 Chrysler Crossfire. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Nut

Courtesy of DAIMLERCHRYSLER CORP.

Connect the accelerator pedal harness connector.
Slide the accelerator pedal into the bracket (1) and then onto the welded stud.

Fig 2: Removing/Installing Accelerator Pedal-To-Floor Nut
Courtesy of DAIMLERCHRYSLER CORP.
Install the accelerator pedal lower nut (1). Tighten to 15 N.m (11 ft. lbs.).
Install the plastic nut cover.
Connect the negative battery cable.