Upstream O2
WARNING: This page is about a different car, the 2006 Chrysler Crossfire. However, it is still accessible from the selected car via links, so may be relevant.
- Apply anti-seize compound to the threaded portion of the O2 sensor.
- Install the O2 sensor (1). Tighten to 50 N.m (37 ft. lbs.).
- Connect the O2 sensor harness connector.
- Install the engine cover. Align the engine cover retaining clips to the rubber mounts, and push down firmly to connect engine cover to rubber mounts.NOTE: To ease the installation of the engine cover, apply a small amount of lubricant to the engine cover rubber mounts.
- Connect the negative battery cable.