Knock Sensor: Installation

WARNING: This page is about a different car, the 2006 Chrysler Crossfire. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Wire Harness Connectors At Knock Sensors

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: The knock sensor bolt torque is higher than other sensors. If the proper torque is not applied to the knock sensor, driveability can be affected.

Position the knock sensors (1) on the engine block.
Install the knock sensor retaining bolts. Tighten the bolts to 20 N.m (15 ft. lbs.).
Connect the wire harness connectors.
Install the intake manifold. (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) - except SRT or (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) - SRT .