LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring Touring, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules >> Electronic Control Modules >> Standard Procedure >> Standard Procedure - Pcm/Skim Programming >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Standard Procedure - Pcm/Skim Programming: Notes

NOTE: Before replacing the PCM for a failed driver, control circuit or ground circuit, be sure to check the related component/circuit integrity for failures not detected due to a double fault in the circuit. Most PCM driver/control circuit failures are caused by internal component failures (i.e. relay and solenoids) and shorted circuits (i.e. pull-ups, drivers and switched circuits). These failures are difficult to detect when a double fault has occurred and only one DTC has set.

When a PCM and the SKIM are replaced at the same time perform the following steps in order:

  1. Program the new PCM.
  2. Program the new SKIM.
  3. Replace all ignition keys and program them to the new SKIM.
scientia non olet · About LEMON Manuals