Section 121 (Cruise Control Systems): Switch: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Speed Control Switch

Courtesy of DAIMLERCHRYSLER CORP.

The speed control switch is mounted in the steering wheel and wired through the clock spring device under the airbag module.

Fig 2: Removing/Installing - Speed Control Switch Positioning

Courtesy of DAIMLERCHRYSLER CORP.

WARNING: If removal of airbag module is necessary, refer to the RESTRAINTS - SERVICE INFORMATION article.

Connect the electrical connector.

Fig 3: Speed Control Switch Fastener (Top Mounting Screw)
Courtesy of DAIMLERCHRYSLER CORP.

1 - TOP MOUNTING SCREW
Install switch and tighten the screws (1) to 1.6 N.m (15 in. lbs.). Make sure rubber seal is in place around switch.
Install airbag, refer to the RESTRAINTS - SERVICE INFORMATION article.
Install the negative battery cable.
Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.