Speed Control Switch

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Speed Control Switch

Courtesy of CHRYSLER LLC

The speed control switch is mounted in the steering wheel and wired through the clock spring device under the airbag module.

Fig 2: Speed Control Switch Fastener (Top Mounting Screw)

Courtesy of CHRYSLER LLC

1 - TOP MOUNTING SCREW

WARNING: If removal of airbag module is necessary, refer to RESTRAINTS - SERVICE INFORMATION .

Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
Remove the negative battery cable.
Turn off ignition.
Remove air bag, refer to RESTRAINTS - SERVICE INFORMATION .
Remove the top mounting screw.

Fig 3: Removing/Installing - Speed Control Switch & Positioning
Courtesy of CHRYSLER LLC
Rotate steering wheel so that the switch is in the 6 o'clock position. Remove 2 screws from the back side of the speed control switch.
Disconnect the electrical connector.
Remove switch.