Unit/Sensor-Fuel Level Sending: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: TRACK

Courtesy of DAIMLERCHRYSLER CORP.

Sensor guide channels in pump module.

Fig 2: TRACK GUIDES
Courtesy of DAIMLERCHRYSLER CORP.
Guide tabs on level sensor.

Fig 3: SENDER LOCKING TABS
Courtesy of DAIMLERCHRYSLER CORP.
Slide level sensor into channel until it snaps into place. Ensure tab of sensor locks in place.

Fig 4: WIRE RETAINER
Courtesy of DAIMLERCHRYSLER CORP.
Install wire into wire retainer.

Fig 5: Removing/Installing Wedge Lock
Courtesy of DAIMLERCHRYSLER CORP.
Install level sensor wires in connector. Push the wires up through the connector and then pull them down until they lock in place. Ensure signal and ground wires are installed in the correct position. Refer to appropriate wiring diagram information.
Install locking wedge on connector.

Fig 6: WIRE TIE
Courtesy of DAIMLERCHRYSLER CORP.
Push connector up into bottom of fuel pump module electrical connector (1).
Install wire tie and bundle wires to fuel tube.
Install fuel pump module (Refer to FUEL SYSTEM/FUEL DELIVERY/FUEL PUMP MODULE - INSTALLATION) .