Removal

REMOVAL





1. Disconnect negative (-) battery cable (2) from battery post and isolate.





2. Disconnect 47-Way wiring connector (5) at ABM (6).





3. Unclip brake tubes (1, 2 and 10) from two routing clips (6) along upper radiator support.

4. Unclip brake tube (3) from routing clip (4) below Fuse And Relay Center.

5. Lift up on entire assembly (5) from mounting grommets (8) and move inboard allowing access to ABM attaching screws. Do not force brake tubes. Move assembly just enough to access mounting screws.





6. Remove three screws (2) attaching ABM (1).





7. Slide ABM (1) off HCU (3).