LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2007 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension System >> Wheel Alignment >> Standard Procedure >> Chassis Alignment Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Chassis Alignment Inspection

  1. Observe the general information on chassis alignment inspection. See STANDARD PROCEDURE .
  2. Drive the vehicle onto an electronic measuring system.
  3. Unlock the turntables and the sliding platforms.
  4. Install a brake pedal winch on the brake pedal.
  5. Attach the wheel sensors.
  6. Perform the initial measurement process.
  7. Inspect the vehicle level at the front and the rear axles and adjust if necessary. See STANDARD PROCEDURE .
  8. Inspect the vehicle level at the front and the rear axles with an electronic inclinometer and adjust if necessary. See STANDARD PROCEDURE .
  9. Inspect and adjust the rear axle toe. See STANDARD PROCEDURE .
  10. Inspect and adjust the front axle camber and caster. See STANDARD PROCEDURE .
  11. Inspect the rear axle camber. See STANDARD PROCEDURE .
  12. Inspect and adjust the front axle toe. See STANDARD PROCEDURE .
  13. Perform the final measurement of the vehicle.
  14. Detach the sensors.
  15. Remove the brake pedal winch.
  16. Carefully drive the vehicle off the measuring system.
  17. Lock the turntables.
scientia non olet · About LEMON Manuals