LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2007 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension System >> Wheel Alignment >> Standard Procedure >> Checking Vehicle Level
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Checking Vehicle Level

  1. Observe the general information on chassis alignment inspection. See STANDARD PROCEDURE .
  2. Inspect the vehicle level at the front axle by performing the following:
    • Insert measuring device between the retaining bolts of the lower control arm bearing.
    • Position the contact arm of measuring device on the control arm and read off the plumb value of vehicle level, viewed from the center of the vehicle. See STANDARD PROCEDURE .
  3. Inspect the vehicle level at the rear axle by performing the following:
    • Loosen right rear frame brace and swivel to one side.
    • Position contact arm on the rear axle shaft and read off the plumb value of the vehicle level, viewed from the center of the vehicle. See STANDARD PROCEDURE .
    NOTE: If the vehicle level is within specification, no further action is required.
  4. Install adjustable rubber spring mounts, as needed, and rotate the mounts until the vehicle level is within specification.
scientia non olet · About LEMON Manuals