Diagnostic Test

Turn the ignition on.

With the scan tool, erase DTCs.

Cycle the ignition switch from Off to Run.

Operate the passenger window switch in all positions several times.

With the scan tool, read DTCs.

Does the scan tool display 3F-LIN WINDOW REGULATED MODULE NOT CALIBRATED? 

Yes 

1. Go To step  2).

No 

1. The condition that caused this code to set is not present at this time. Operate the motor several times more to ensure the express up feature is operational. If it is not, calibrate the module by running the window motor all the way down then all the way up. Hold the switch in full up position for 1 second after the window reaches the full up position.
2. Perform BODY VERIFICATION TEST - VER 1 .

Run the window motor all the way down then all the way up. Hold the switch in full up position for 1 second after the window reaches the full up position.

With the scan tool, erase DTCs.

Cycle the ignition switch from Off to Run.

Operate the passenger window switch in all positions several times.

With the scan tool, read DTCs.

Does the scan tool display 3F-LIN WINDOW REGULATED MODULE NOT CALIBRATED? 

Yes 

1. Replace the Passenger Window Motor (regulator) in accordance with service information.
2. Perform BODY VERIFICATION TEST - VER 1 .

No 

1. Test complete.
2. Perform BODY VERIFICATION TEST - VER 1 .