Alarm Module: Testing and Inspection

SKIS INITIALIZATION

The Sentry Key Immobilizer System (SKIS) must be initialized following a Sentry Key REmote Entry Module (SKREEM), sometimes referred to as the Wireless Control Module (WCM), replacement. SKIS initialization requires the use of a diagnostic scan tool. Initialization will also require that you have access to the unique four-digit PIN code that was assigned to the original SKREEM/WCM. The PIN code MUST be used to enter the Secured Access Mode in the SKREEM/WCM. This PIN number may be obtained from the vehicle owner, from the original vehicle invoice, or from the Chrysler Customer Center .

NOTE: If a Powertrain Control Module (PCM) is replaced on a vehicle equipped with the Sentry Key Immobilizer System (SKIS), the unique Secret Key data must be transferred from the Sentry Key REmote Entry Module (SKREEM) to the new PCM using the appropriate programming procedure. This procedure also requires the use of a diagnostic scan tool and the unique four-digit PIN code to enter the Secured Access Mode in the SKREEM/WCM.