Integrated Power Module

Fig 1: Battery & Cables

Courtesy of CHRYSLER LLC

NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. Refer to STANDARD PROCEDURE .

Disconnect and isolate the battery negative cable (2).

Fig 2: Disconnecting/Connecting Negative Battery Cable
Courtesy of CHRYSLER LLC
Open the battery cable nut cover to expose nut.
Remove battery cable nut and battery cable from the Integrated Power Module (IPM).

Fig 3: Integrated Power Module
Courtesy of CHRYSLER LLC
Disengage the outboard retaining clip, and rotate the TIPM to access wire harness connectors.
Disconnect wire harness connectors from TIPM.
Disengage the two inboard retaining clips.

Fig 4: IPM Retaining Clips
Courtesy of CHRYSLER LLC
Remove TIPM from vehicle.