LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2008 >> Sebring Base, 2D Convertible, 2.4 K >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Electronic Control Modules - Service Information >> Module-Powertrain Control >> Removal >> Powertrain Control Module (Pcm) - GPEC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (Pcm) - GPEC

Fig 1: Removing/Installing PCM - 2.0L/2.4L
GC0058941Courtesy of CHRYSLER LLC
CAUTION: Do not disconnect the Powertrain Control Module (PCM) electrical connectors before the ignition key is in the off position and the battery cable disconnected. If these steps are not preformed damage to the PCM may result from a voltage spike.
NOTE: Note radio programs prior to disconnecting the battery.
  1. Disconnect and isolate negative battery cable at battery.
  2. Remove the Air Cleaner Housing. Refer to REMOVAL for 2.4L. Refer to REMOVAL for 2.7L. Refer to REMOVAL for 3.5L.
  3. Disconnect the electrical connectors (3) from PCM.
  4. Remove nut (1) from upper shock tower stud.
  5. Remove bolt (2) from lower shock tower fastener.
  6. Remove the PCM and bracket (4) from vehicle.
    Fig 2: Removing/Installing PCM From Bracket - 2.0L/2.4L
    GC0072077Courtesy of CHRYSLER LLC
  7. Remove bolts (3) and separate the PCM (2) from bracket (1).
scientia non olet · About LEMON Manuals