Integrated Power Module

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: IPM Retaining Clips

Courtesy of CHRYSLER LLC

NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. Refer to STANDARD PROCEDURE .

Position Totally Integrated Power Module (TIPM) to vehicle. Engage the three retaining clips.

Fig 2: Integrated Power Module
Courtesy of CHRYSLER LLC
Disengage the outboard retaining clip and rotate the TIPM to access wire harness connectors.
Connect electrical harness connectors to TIPM.

Fig 3: Disconnecting/Connecting Negative Battery Cable
Courtesy of CHRYSLER LLC
Connect battery cable to TIPM.
Install and tighten retaining nut.
Close the battery cable nut cover.

Fig 4: Battery & Cables
Courtesy of CHRYSLER LLC
Connect battery negative cable (2).