Diagnostic Test

CHECK IF TIPM/FCM CAN BUS DTCS ARE PRESENT
1. With the scan tool, read TIPM/FCM DTCs.
  Are there any TIPM/FCM CAN BUS DTCs present?
  
  Yes
  - Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing and perform the appropriate symptom. Perform the diagnostic procedure for U0002-CAN C BUS OFF PERFORMANCE first if it is present.
  - Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .
  No
  - Go to step 2
CHECK IF ENGINE DTCS ARE PRESENT
1. With the scan tool, read Engine DTCs.
  Are there any Engine DTCs present?
  
  Yes
  - Perform the appropriate diagnostic procedure.
  - Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .
  No
  - Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM in accordance to the Service Information.
  - Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .