LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2010 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> Electrical >> Body Electrical >> Electronic Control Modules (Service Information) >> MODULE, Powertrain Control >> Removal >> Removal - GPEC Controller
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal - GPEC Controller

Fig 1: Removing/Installing GPEC
GC0085578Courtesy of CHRYSLER LLC
CAUTION: Do not disconnect the Powertrain Control Module (PCM) electrical connectors before the ignition key is in the off position and the battery cable disconnected. If these steps are not performed damage to the PCM may result from a voltage spike.
NOTE: Note radio programs prior to disconnecting the battery.
  1. Disconnect and isolate negative battery cable at battery.
  2. Remove the Air Cleaner Housing. Refer to the appropriate service information.
  3. Disconnect the electrical connectors (3) from PCM.
  4. Remove nut (1) from upper shock tower stud.
  5. Remove bolt (2) from lower shock tower fastener.
  6. Remove the PCM and bracket (4) from vehicle.
    Fig 2: Removing/Installing PCM From Bracket - 2.0L/2.4L
    GC0120941Courtesy of CHRYSLER LLC
  7. Remove bolts (3) and separate the PCM (2) from bracket (1).
scientia non olet · About LEMON Manuals