LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 982 (Electronic Control Modules (Service Information)) >> Module, Keyless Ignition Node >> Removal And Installation >> Removal And Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Installation

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

For mechanical key ignition, refer to SWITCH, IGNITION, REMOVAL AND INSTALLATION .

  1. Position the KIN, then install and securely tighten the screws.
  2. Connect the KIN wire harness connector.
  3. Install the lower steering column cover.
  4. Turn the steering wheel to the middle position and secure it with the position lever.
  5. Install the instrument cluster bezel to the instrument panel. Refer to REMOVAL AND INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  7. If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.
scientia non olet · About LEMON Manuals