Diagnostic Test
- CHECK FOR BCM CAN BUS DTCS
- With the scan tool, read BCM DTCs.
Are there any BCM CAN BUS DTC's present?
Yes
- Perform the diagnostic procedure for DTC U0001-CAN C BUS first if it is present. Refer to DIAGNOSIS AND TESTING and perform the appropriate symptom.
- Refer to Standard Procedure and perform the NAG1 TRANSMISSION VERIFICATION TEST.
No
- Go To 2.
- With the scan tool, read BCM DTCs.
- CHECK IF ENGINE DTC'S ARE PRESENT
- With the scan tool, read engine DTCs.
Are there any engine DTC's present?
Yes
- Refer to 3.6L - DIAGNOSTIC CODE INDEX or 5.7L - DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.
- Refer to Standard Procedure and perform the NAG1 TRANSMISSION VERIFICATION TEST.
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM in accordance to the Service Information.
- Refer to Standard Procedure and perform the NAG1 TRANSMISSION VERIFICATION TEST.
- With the scan tool, read engine DTCs.