Heated Seat Module - Installation

INSTALLATION

CAUTION: Properly align the Heated Seat Module (HSM) retaining tab to the hole in the seat pan, prior to engagement. Failure to follow these instructions may result in damage to the plastic HSM housing and retaining tab.





1. Position the Heated Seat Module (HSM) (3) to the seat pan (1) and connect the wire harness connector (4).
2. Align the HSM retaining tab (2) to the hole in the seat pan and enage the retaining tab to the seat. Firmly apply even pressure to the HSM until the retaining tab is fully engaged.
3. Reconnect the negative battery cable.
4. Check for proper heated seat system operation.