Removal

3.6L





1. Disconnect and isolate the negative battery cable (1).





2. Lift the engine cover retaining grommets off the ball studs and remove the engine cover (1).





3. Disconnect the electrical connector (1) from the Inlet Air Temperature (IAT) sensor.





4. Clean any dirt from the air inlet tube at the IAT sensor base.
5. Gently lift the small plastic release tab (3), rotate the sensor about 1/4 turn counterclockwise and remove the sensor from the inlet air hose.
6. The IAT sensor O-ring (2) can be reused if not damaged.