Module, Integrated Center Stack (ICSM): Removal
WARNING: This page is about a different car, the 2018 Dodge Challenger. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- For manual shifter using a trim stick or equivalent, carefully release the retaining clips and lift the shifter boot (1).
- Remove the bolts (3) then the shift lever (2).
- For automatic shifter, place the shifter in the Neutral position.
- Using a trim stick or equivalent, carefully release the retaining clips and lift the shifter bezel (2).
- Remove the screw (4) then lift the shifter knob (1) and remove.
- Using a trim stick or equivalent, starting at the rear carefully release the retaining clip and lift the shifter bezel panel (1). Disconnect the wire harness connectors and remove.
- Remove the four screws (2) from the Integrated Center Stack (ICS) (1) to the shifter bezel panel.