Front Toe
- Center the steering wheel and lock in place using a steering wheel clamp.NOTE: Perform the following steps to each side of the vehicle as necessary.CAUTION:
Do not twist inner tie rod-to-steering gear boots during front wheel Toe adjustment. Remove boot clamps at the inner tie rods and make sure boots moves freely on inner tie rod.
NOTE: Adjust left front toe first then right front toe. - Loosen jam nut at inner-to-outer tie rod connection.
1 - Jam Nut 2 - Outer Tie Rod End 3 - Tie Rod End Nut - Grasp inner tie rod and rotate as necessary to adjust front toe to preferred toe specification. Refer to WHEEL ALIGNMENT, TECHNICAL SPECIFICATIONS .
- Tighten tie rod jam nut to the proper torque specifications. Refer to TORQUE SPECIFICATIONS
.NOTE: Verify the inner tie rod-to-steering gear boot is not twisted, then reinstall boot clamp at inner tie rod.
- Adjust front toe on opposite side of vehicle using above procedure as necessary.
- Remove steering wheel clamp.
- Remove alignment equipment.
- Road test vehicle to verify steering wheel is straight and vehicle does not wander or pull.