LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1981 >> Cutaway >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Electronic Ignition >> Overhaul >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronic Ignition: Overhaul: Reassembly

  1. Test operation of governor weights and inspect the weight springs for distortion. Lubricate governor weights. Inspect all bearing surfaces and pivot pins for roughness, binding, or looseness. Lubricate and install upper thrust washer on shaft and slide shaft into distributor housing.
  2. Install lower thrust washer and original collar on lower end of shaft, and install retaining pin. If collar is not in good condition, replace it.
  3. Install lower plate, upper plate, and dual pick-up coil assembly. Attach vacuum advance unit arm to pick-up plate and install attaching screws.
  4. Position reluctor keeper pin into place on reluctor sleeve. Slide reluctor down reluctor sleeve and press firmly into place. Make sure keeper pin is in place. Lubricate felt pad in top of reluctor sleeve and install rotor.
scientia non olet · About LEMON Manuals