LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1986 >> Mini Ram Van Base, 2.2 C, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> 2.2L EFC System >> Removal & Installation >> Spark Control Computer >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

  1. Remove battery. Disconnect 10-pin and 14-pin connectors from computer. Disconnect air duct and vacuum hose from vacuum transducer.
    NOTE: Do not remove grease from harness connectors or connector cavities in computer. Grease is used to prevent moisture from corroding terminals. If there is not at least 1/8" of grease on bottom of computer connector cavities, apply a liberal amount of Mopar Multipurpose Grease (Part No. 2932524) over entire end of connector plug before reinstallation.
  2. Remove 3 mounting screws holding computer to fender well. Remove computer. To install, reverse removal procedure.
NOTE: Computer is not serviceable. Do not attempt disassembly for any reason. If vacuum transducer is defective, replace entire computer.
scientia non olet · About LEMON Manuals