Coolant Temperature Sensor/Switch (For Computer): Service and Repair

Ignition Coil And Coolant Temperature Sensor Location:

REMOVAL
1. Drain cooling system until coolant level is below sensor.
2. Disconnect coil pack electrical connector to sensor.
3. Remove coil mounting screws.
4. Rotate coil away from coolant temperature sensor.
5. Disconnect electrical connector from coolant temperature sensor.
6. Remove sensor from engine.


INSTALLATION
1. Tighten the coolant sensor to 7 Nm (60 in lbs) torque.
2. Connect electrical connector to sensor.
3. Fill cooling system. Refer to Cooling System.
4. Install coil. Tighten coil mounting screws to 12 Nm (105 in lbs) torque.
5. Connect electrical connector to coil.