Power Door Lock Test 9A - Right Door Lock Switch Failure
NOTE:
Perform POWER DOOR LOCK TEST 1B
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Clear trouble codes as needed. Using scan tool, read passenger's door zone switch voltage. If RF DOOR ZONE SWITCH voltage is about 3 volts, replace passenger's door lock switch. If RF DOOR ZONE SWITCH voltage is not about 3 volts, go to next step.
- Operate passenger's door lock switch to lock position and observe voltage on scan tool. Do not hold switch in lock position for more than 7 seconds or code will set. If RF DOOR ZONE SWITCH voltage is about 3 volts, go to next step. If RF DOOR ZONE SWITCH voltage is not about 3 volts, replace passenger's door lock switch.
- Operate passenger's door lock switch several times from unlock to lock position. Release switch. With switch in neutral position, observe scan tool voltage. If RF DOOR ZONE SWITCH voltage is about 5 volts, system is currently functioning correctly. If RF DOOR ZONE SWITCH voltage is not about 5 volts, replace passenger's door lock switch.