Installation

INSTALLATION

NOTE: Front Control Module must be programmed to the correct radio EQ curve using the DRBIII(R). This will ensure that the audio system is operating correctly.

1. Install the Front Control Module (FCM) in the Power Distribution Center (PDC) assembly by pushing the 49-way electrical connector straight in.

2. Install the FCM retaining screws. Torque the screws to 1 Nm (7 in.lbs).

3. Rotate the IPM assembly downward to secure in mounting bracket.

4. Install the battery in the vehicle.

5. Connect the positive and negative battery cables.

6. Using the DRBIII(R), under "FRONT CONTROL MODULE" then "MISC" program the EQ curve of the radio into the Front Control Module.

NOTE: If the vehicle is not equipped with Name Brand Speakers (Infinity, etc.) or Headlamp Washers the DRBIII(R) must be used to Disable the appropriate relays in the Integrated Power Module Assembly.