Speed Control Switch - Removal

REMOVAL






WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag and possible serious personal and/or fatal injury may result.

NOTE: Position the front wheels straight ahead.

1. Disconnect and isolate the negative battery cable before beginning steering wheel removal. Allow the front airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component.
2. Remove the driver airbag (3) Driver Air Bag - Removal.
3. Disconnect the speed control switch electrical connector (2).
4. Remove the screw (1) from the front of the speed control switch (3).





5. Remove the screws (1) from the rear of the speed control switch (2).
6. Remove the speed control switch (2) from the steering wheel.