Section 2 (Rear Driveline Module): Installation: Installation

Fig 1: Seal Protector

Courtesy of CHRYSLER LLC

1 - HALFSHAFT

2 - SEAL PROTECTOR

1. Install driveline module to transmission jack. Secure module to jack.
2. Using Seal Protector 9099 (2), load halfshafts to differential, one side at a time. Clean tool and seal area to prevent debris intrusion.
   Fig 2: Support Module With Jack

   Courtesy of CHRYSLER LLC

   1 - DRIVELINE MODULE

   2 - TRANSMISSION JACK

3. Raise driveline module (1) into position.
   Fig 3: Removing /Installing Propeller Shaft

   Courtesy of CHRYSLER LLC
4. Align marks (4) on propeller shaft rubber coupler (1) to rear axle input flange (5).
5. Install three rear propeller shaft to rear axle retaining bolts (3) but do not tighten at this time.
   Fig 4: RDA TO CROSSMEMBER BOLTS

   Courtesy of CHRYSLER LLC
6. Install the RDA - to - crossmember mounting bolts (1) and tighten to 102 N.m (75 ft. lbs.).
   Fig 5: RDA REAR MOUNT

   Courtesy of CHRYSLER LLC
7. Install the rear RDA - to - crossmember mounting bolt (2) to 102 N.m (75 ft. lbs.)
8. Tighten propeller shaft-to-driveline module bolts to 58 N.m (43 ft.lbs.).
9. Raise exhaust system into position and install hanger/brackets.
10. Fill differential with 0.7L (0.74 Quarts) of Mopar® Gear and Axle Lubricant (75W-90). See Differential and Driveline/Rear Driveline Module/FLUID - Standard Procedure .