LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2020 >> ProMaster 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Front Axle) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Section 17 (Front Axle): Installation

WARNING: This page is about a different car, the 2020 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
GC0081412Courtesy of CHRYSLER GROUP, LLC
  1. Install the front axle assembly (1) into position.
  2. Install and tighten the axle housing-to-engine bolts to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
    GC0080564Courtesy of CHRYSLER GROUP, LLC
  3. Install power steering return line to cradle by fastening clips (1).
    GC0081411Courtesy of CHRYSLER GROUP, LLC
  4. Install axle assembly support bracket (1) and bolts (2) and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
  5. Install the front axle disconnect. Refer to DISCONNECT, FRONT AXLE, INSTALLATION .
  6. Install RH catalytic converter/exhaust pipe assembly. Refer to CONVERTER, CATALYTIC, INSTALLATION .
  7. Install front driveshaft. Refer to INSTALLATION .
  8. Install both front halfshafts. Refer to INSTALLATION .
    GC0081451Courtesy of CHRYSLER GROUP, LLC
  9. Fill the axle with the specified fluid. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .
  10. Tighten the fill plug (1) to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
    NOTE:

    Fluid level should be at or near the bottom of the fill hole.

  11. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals