Removal And Installation: Removal

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Drain the cooling system. Refer to DRAINING THE COOLING SYSTEM .
Remove the screw (2), four bolts (3 and 4) and the right lower splash shield (1).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown in illustration, right side similar.
Remove the four bolts (1) holding the front of the right and left load beams to the radiator support. Do not remove the nut (2).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown in illustration, right side similar.
Remove the two lower bolts (3) and the lower radiator core support (4).

Courtesy of CHRYSLER GROUP, LLC
Lower the vehicle.
Remove the two bolts (2), lift the pressurized coolant bottle (1) from the rubber grommet and reposition the coolant bottle.

Courtesy of CHRYSLER GROUP, LLC
Disengage the quick-connect coupling and remove the upper radiator inlet hose (1) from the radiator.

Courtesy of CHRYSLER GROUP, LLC
Unlock and disconnect the radiator cooling fan harness connector (4).
Unlock and disconnect the radiator cooling fan speed control module harness connector (3).
Disengage the wire harness retainer (2) form the fan shroud and reposition the wire harness.
Disengage the transmission oil cooler line retainer (1) from the radiator fan shroud and reposition the oil cooler lines.

Courtesy of CHRYSLER GROUP, LLC
Remove the two bolts (2) securing the power steering fluid cooler (1) to the front bumper reinforcement and reposition the power steering fluid cooler.

Courtesy of CHRYSLER GROUP, LLC
Detach the wire loom retainers (1) from the front bumper reinforcement (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the four right side front bumper reinforcement mounting bolts (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the four left side front bumper reinforcement mounting bolts (1) and remove the front bumper reinforcement (2) from the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Remove the two screws (3) from the bottom of the shroud (1).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown in illustration, right side similar.
Remove the shroud (1) by squeezing the upper retention tabs (2) together while gently pulling the shroud away from radiator.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Right side shown in illustration, left side similar.
Push up on the retainers (2), lift the mount tabs (4) out of the radiator mounts (5) and reposition the transmission oil cooler (3).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Right side shown in illustration, left side similar.
Carefully spread the lock tabs (2) and disengage the A/C condenser (1) from the radiator.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Right side shown in illustration, left side similar.
Lift the mount tabs (2) out of the radiator mounts and reposition the A/C condenser (1).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown in illustration, right side similar. Headlight removed for clarity.
Remove the bolts (1) and remove the radiator/cooling fan assembly from the vehicle.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown in illustration, right side similar.
Remove the upper radiator mounting brackets (1) from the radiator.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Right side shown in illustration, left side similar.
Press the retainers (1), lift the radiator fan shroud up off of the radiator mounts (2) and remove the fan shroud from the radiator.