LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1993 >> Vision ESi >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Self-Diagnostic System >> Speed Control Menu
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Speed Control Menu

  1. To perform cruise control system tests using DRB-II, DRB-II must be in SPEED CONTROL MENU. At SPEED CONTROL MENU, fault codes and DRB-II test functions can be accessed. To reach SPEED CONTROL MENU, turn ignition off. Connect DRB-II to data link connector. Connector is located in engine compartment, under center of dash, right of steering column. Turn ignition switch to RUN position.
    NOTE: DO NOT  touch DRB-II keypad during DRB-II power-up sequence or an error message will result.
  2. All DRB-II character positions will glow and copyright information will appear on screen for a few seconds. If the DRB-II screen is blank or if any error messages appear, refer to the appropriate TESTS W/CODES - BODY CONTROL COMPUTER article in ENGINE PERFORMANCE.
  3. After a few seconds DRB-II menu will appear. At DRB-II menu, press "4" (SELECT SYSTEM) key. Press ENTER key. At SELECT SYSTEM menu, press "1" (ENGINE) key. Press ENTER key. DRB-II menu will appear indicating engine year, size, type of transmission and PCM part number.
  4. After a few seconds AIR COND menu will appear. Press "1" (WITH A/C) or press "2" (WITHOUT A/C). DRB-II display will change to ENGINE SYSTEMS menu. At ENGINE SYSTEMS menu, press "3" (SPEED CONTROL) key. Press ENTER key.
  5. Display will change to SPEED CONTROL. At SPEED CONTROL MENU, specific test functions programmed into DRB-II can be performed. Following DRB-II modes can be accessed: SYSTEM TESTS, READ FAULTS, STATE DISPLAY, ACTUATOR TESTS and ADJUSTMENTS.
scientia non olet · About LEMON Manuals