Test 51C - Repairing Key-In Lamp On Constantly

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAMS . Perform TEST VER-1 after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.

Turn ignition switch to OFF position. Disconnect Body Control Module (BCM) Bone connector. If key-in lamp goes off, replace BCM. If key-in lamp does not go off, repair short to ground in Yellow/Red wire.