Transmission Control Module (TCM) Configuration

This TCM table lists the necessary scan tool operations that are mandatory along with the order in which they are to be performed:

NOTE:

The transmission clutches must be above a certain temperature threshold before performing the Quick Learn Procedure. Drive vehicle and allow 5-6 up shifts and down shifts. If the Quick Learn procedure does not finish, drive the vehicle and perform 5-6 additional up shifts and down shifts.

NOTE:

If the Transmission and TCM are replaced as an assembly, do not perform and of these procedures. The transmission and matched TCM are calibrated at the factory and should be ready for optimal performance.

Scan Tool Procedure Order / Component Replacement	1	2	3	4
TCM Replacement	Rewrite Historical Data	Quick Learn	Clutch Contact Point Calibration	-
Solenoid Replacement	New Actuators	Hydraulic Circuit Bleed	Quick Learn	-
Valve Body Replacement	Valve Body Replacement	Hydraulic Circuit Bleed	Quick Learn	Clutch Contact Point Calibration
Gearbox Replacement	Gearbox Replacement	Reset All Data	Quick Learn	Clutch Contact Point Calibration
Pump Replacement	Hydraulic Pump Replacement	Hydraulic Circuit Bleed	-	-
Integrated Sensor Module Replacement	Integrated Sensor Module Replacement	Quick Learn	Clutch Contact Point Calibration	-
ODD clutch position sensor Replacement	ODD clutch position sensor Replacement	Hydraulic Circuit Bleed	Quick Learn	Clutch Contact Point Calibration
EVEN clutch pressure sensor Replacement	EVEN clutch pressure sensor Replacement	Hydraulic Circuit Bleed	Quick Learn	Clutch Contact Point Calibration
Dual Clutch Assembly Replacement	Dual Clutch Assembly Replacement	Hydraulic Circuit Bleed	Quick Learn	Clutch Contact Point Calibration
Accumulator Replacement	Accumulator Replacement Only	Hydraulic Circuit Bleed	-	-
SDU (Smart Driver Unit) Replacement	SDU (Smart Driver Unit) Replacement	-	-	-