LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Fiat >> 2018 >> 124 Spider Classica, Automatic Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Direct System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Direct System

NOTE: If a tire pressure sensor has been replaced, the TPM system needs to relearn tire pressure sensor IDs.

If warning light is lit continuously due to low pressure in one or more tires, adjust tire inflation to specification. The light will remain on until tire pressure is properly set. After adjusting air pressure in a tire, allow approximately two minutes for the message or indicator lamp to go out.

After a sensor has been replaced, the WCM automatically learns and stores the sensor's ID while driving continuously above 15 mph (24 Km/h) for 10 minutes. During this time, the system will learn the new sensor ID code and will clear any DTCs automatically. The learning sequence will initiate when the vehicle has been stopped for more then 20 minutes. If a sensor cannot be trained, see appropriate manufacturer service information.

NOTE: A new sensor ID can also be programmed directly into the WCM by using a RKE-TPM Analyzer in conjunction with a Scan Tool. Once the new sensor ID has been programmed, the RKE-TPM Analyzer can be used to update the TPMS by activating the sensor.
scientia non olet · About LEMON Manuals