Coil, Ignition: Installation

Courtesy of CHRYSLER GROUP, LLC

Using compressed air, blow out any dirt or contaminants from around the top of spark plug.
The ignition coil seal (1) can be reused if not damaged.
Check the condition of the ignition coil rubber boot (2). To aid in ignition coil installation, apply a silicone based grease such as Mopar® Dielectric Grease # J8126688 into the spark plug end of the rubber boot (3).

Courtesy of CHRYSLER GROUP, LLC
Position the ignition coil (3) into the cylinder head cover opening. Using a twisting action, push the ignition coil onto the spark plug.
Install the ignition coil mounting bolt (2) and tighten to 9 N.m (80 in. lbs).
Connect and lock the electrical connector (3) to the ignition coil (1).

Courtesy of CHRYSLER GROUP, LLC
Connect the oil vapor recovery pipe and tighten the clamp (1).

Courtesy of CHRYSLER GROUP, LLC
Install and tighten the engine oil vapor pipe middle bracket bolt (1).
Install the engine cover. Refer to COVER, ENGINE, INSTALLATION .
Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).