Removal And Installation: Installation

WARNING: This page is about a different car, the 2019 Fiat 500X. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Position the compass module (3a) into the bracket (3b) and install the appropriate rivets (2).
Connect the compass module wire harness connector (1).
Install the instrument panel glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, LOWER, INSTALLATION and GLOVE BOX, INSTRUMENT PANEL, UPPER, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.