LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Fiat >> 2020 >> 500L Lounge >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Electronic Control Modules (Service Information)) >> Module, Engine Cooling Fan Control >> Removal And Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation

WARNING: This page is about a different car, the 2020 Fiat 124 Spider. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL 

  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION .
    GC0175859Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the engine cooling fan control unit wire harness connector (1).
  4. Remove the engine belly pan. Refer to BELLY PAN, ENGINE, REMOVAL AND INSTALLATION .
    GC0176480Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the engine cooling fan control unit wire harness connector (1).
  6. Remove the screws (2a) to remove the engine coolant fan control unit (2b).

INSTALLATION 

  1. Position the engine cooling fan in its housing and tighten the screws.
  2. Connect the lower engine cooling fan control unit wire harness connector.
  3. Install the engine belly pan. Refer to BELLY PAN, ENGINE, REMOVAL AND INSTALLATION .
  4. Connect the upper engine cooling fan control unit wire harness connector.
  5. Install the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals