Right-Hand Drive

WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Clean any debris off the mating surfaces of the HCU and ABM.
CAUTION:
When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant.

Courtesy of CHRYSLER GROUP, LLC

1 - SEAL

2 - SOLENOID VALVE STEM
If the seals (1) on the solenoid valve stems (2) are not new, replace them all. Each of the solenoid valve stem seals must be new to keep out moisture and debris;do not reuse solenoid valve stem seals.

Courtesy of CHRYSLER GROUP, LLC

1 - O-RING

2 - O-RING MOUNTING GROOVE
Replace the pump/motor connector O-ring (1) if it is not new. Be sure the O-ring is properly seated in the mounting groove (2).

Courtesy of CHRYSLER GROUP, LLC

1 - ABM

2 - HCU

3 - SOLENOID VALVE STEM
Align components and install the ABM (1) on the HCU (2).

Courtesy of CHRYSLER GROUP, LLC

1 - MOUNTING FASTENERS

2 - ABM
Install the four fasteners (1) attaching the ABM (2) to the HCU. Tighten the ABS ABM mounting fasteners to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC

1 - ABM (PART OF ICU)

2 - WIRING HARNESS CONNECTOR

CAUTION:
Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.
Insert the ABM wiring harness connector (2) into the socket of the ABM (1) and close the cover, locking the connector in place.
Install the air inlet hose (1) between the air cleaner housing and engine.
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
Connect the diagnostic scan tool to initialize the ABM and perform the following:
1. Clear any faults.
2. Perform the ABS Verification Test and road test the vehicle Refer to ABS VERIFICATION TEST .