Left-Hand Drive

WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The ABM is only separately serviceable for non-HSA (Hill Start Assist) equipped vehicles. Do not remove the ABM for vehicles equipped with HSA.

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the engine appearance cover.

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1) securing the cowl top screen at the ends. Remove the remaining fasteners (2). Remove the cowl top screen (3).
Remove the wiper arms Refer to ARM, WIPER, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1) securing the cowl screen to the wheelhouse brace and cowl. Rotate the fasteners (2) in the center of the cowl screen 90° clockwise to release the screen. Remove the cowl screen (3).

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1) securing the wheel house brace to the strut towers.
Remove the wheelhouse brace (2).
Remove fasteners, then remove the fresh air plenum.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Loosen, but do not remove, the fasteners (2) attaching the ICU (1) mounting bracket to the body.
Lift the ICU and mounting bracket (1) upward to near the top of the slots in the bracket, then snug one or both of the fasteners (2) to hold the ICU in this position.
Lower the vehicle.
CAUTION:
Before disassembling the ICU, the ICU must be thoroughly cleaned. This must be done to prevent dirt particles and debris from entering into vital areas of the ICU.
Thoroughly clean all surfaces of the ICU and brake tubes. Use only a solvent such as Mopar® Brake Parts Cleaner or equivalent.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Use this figure in the following step to release the ABM harness connector cover. It shows the location of the release tabs.

Courtesy of CHRYSLER GROUP, LLC

1 - ABM (PART OF ICU)

2 - WIRING HARNESS CONNECTOR
Disconnect the ABM harness connector from the Antilock Brake Module (ABM). To do so:
1. Depress the tabs on each side of the connector cover, then
2. Pull outward and upward on the lower half of the cover until it locks into position pointing straight outward (2). The connector can then be pulled straight outward off the ABM (1).
Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1) attaching the ABM (2) to the HCU. A Torx T20 bit approximately 2 inches long works well.

Courtesy of CHRYSLER GROUP, LLC

1 - ABM

2 - HCU

3 - SOLENOID VALVE STEM

CAUTION:
When removing the Antilock Brake System (ABS) module from the HCU, be sure to completely separate the two components (approximately 38 mm (1.5 inches)) before removing the ABS. Otherwise, damage to the pressure sensor or pump motor connection may result, requiring HCU replacement. Do not to touch the sensor terminals on the HCU side or the contact pads on the ABS side as this may result in contamination and issues in the future.
Separate the ABM (1) from the HCU (2).