Intermittent Operation Test
- If ignition system becomes operative during testing without a repair having been made, attempt to recreate original problem. With engine running, wiggle wires at coil, module, distributor and other harness connectors. Check connections that you have previously disconnected.
- Check distributor ground connection. Turn engine off. Heat stator pick-up coil by placing a 250 watt heat lamp approximately 1-2 inches (25-50 mm) from its top surface. Apply heat for 5-10 minutes, while checking pick-up coil resistance at distributor Orange and Purple wires. Resistance should be 400-1000 ohms. Tapping with screwdriver may also be helpful.
- With engine running, heat control module in the same manner. DO NOT let module temperature exceed 212°F (100°C). If ignition system malfunctions, substitute (but do not install) a new control module. If malfunction is corrected, recheck old control module before replacing it.