LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1995 >> Contour SE, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Pinpoint Tests >> Pinpoint Test C - Abs Relay Failure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test C - Abs Relay Failure

  1. Check Circuit No. 90

    Turn ignition off. Disconnect ABS control module 22-pin connector and Hydraulic Control Unit (HCU) 8-pin connector. See COMPONENT LOCATIONS . Connect Breakout Box (007-00033) and Adapter (007-00115). Measure voltage between test pins No. 25 and 30 at breakout box. If voltage is less than 10 volts, go to next step. If voltage is 10 volts or more, replace ABS relay. Reconnect all components and recheck system operation.

  2. Check Fuse Output

    Remove No. 3 (60-amp) fuse at engine compartment fuse block. Measure voltage between ground and output side of No. 3 fuse cavity (Red/Yellow wire). If voltage is less than 10 volts, go to next step. If voltage is 10 volts or more, repair open Red/Yellow wire between fuse block and ABS control module.

  3. Check Fuse Input

    Measure voltage between ground and input side of No. 3 fuse cavity (Red wire). If voltage is less than 10 volts, repair Red wire between battery and fuse block. Replace fuse, reconnect all components and recheck system operation. If voltage is 10 volts or more, repair or replace engine compartment fuse block as necessary. Reconnect all components and recheck system operation.
scientia non olet · About LEMON Manuals