No Power To Servo
- Check IGN Power - Turn ignition on. Test for battery voltage between servo harness connector pins No. 7 (Gray/Yellow wire) and chassis ground. If battery voltage exists, go to next step. If battery voltage does not exist, repair Gray/Yellow or Purple/Orange wire as appropriate.
- Check Ground Circuit - Turn ignition off. Measure resistance between servo harness connector pin No. 10 (Pink/Orange wire) and ground. If resistance is less than one ohm, go back to step 1) of SPEED CONTROL INOPERATIVE test. If resistance is not less than one ohm, repair Pink/Orange wire to ground.