Retrieve/Clear Continuous DTCS

Retrieve/Clear Continuous DTCs
1. Perform Hookup and Vehicle Selection.

NOTE: The ignition switch must be in RUN or test will fail.

2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module to test by rotating dial to highlight module and press trigger.
4. Menu item "Diagnostic Test Modes" is highlighted. Press trigger.
5. Rotate dial to menu item "Retrieve/Clear Continuous DTC", press trigger, then press start (Button 3).
6. To clear an individual DTC from selected module, highlight DTC by rotating dial then press Button 8.
7. To clear all DTCs from selected module, press Button 7.