Memory Switch

Remove memory switch and disconnect harness connector. Measure resistance between appropriate memory switch terminals with switch in specified position. See MEMORY SWITCH RESISTANCE table. See Fig 1 . If resistance is not as specified, replace memory switch.

MEMORY SWITCH RESISTANCE

Switch Position

Between Terminals No.

Ohms

Neutral ⁽¹⁾

1 & 6

More Than 10/k

SET

1 & 6

Less Than 5

MEM 1

4 & 6

Less Than 5

MEM 2

3 & 6

Less Than 5

⁽¹⁾	Terminals No. 8 and 9 are for the switch LED, which has a diode. Resistance between terminals No. 8 and 9 should be infinite. When ohmmeter leads are reversed, resistance should be low resistance.

Fig 1: Identifying Memory Switch Terminals

Courtesy of FORD MOTOR CO.