Ignition Cable: Service and Repair

REMOVAL

CAUTION:
^ Spark plug wires must be connected to the correct ignition coil terminal.
^ When removing the spark plug wire, a slight twisting motion will break the seal and ease removal.







1. Disconnect the spark plug wire at the spark plug.







2. Disconnect the spark plug wire from the ignition coil by slight twisting while pulling upward.
3. Open the spark plug wire separators and remove the spark plug wire.

INSTALLATION
1. To install, reverse the removal procedure.

NOTE: Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification ESE-M1C171-A to the inside of spark plug and ignition coil boots of the spark plug wire.