Idle Speed/Throttle Actuator - Electronic: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.







2. Disconnect the Idle Air Control (IAC) valve electrical connector.







3. Disconnect the throttle bypass hose.







4. Remove the two bolts and the IAC valve.

INSTALLATION







1. Install the IAC valve and tighten the bolts in two stages:
^ Stage 1: Tighten to 10 Nm (89 Lb-In).
^ Stage 2: Tighten an additional 90 degrees.







2. Connect the throttle bypass hose.







3. Connect the IAC electrical connector.
4. Connect the battery ground cable.