Leak Detection Valve: Service and Repair

REMOVAL







1. Disconnect the canister vent solenoid electrical connector.







2. Remove the canister vent solenoid from the Evaporative Emission (EVAP) canister.

NOTE: A twisting and pulling motion is necessary to remove the canister vent solenoid.

INSTALLATION
1. To install, reverse the removal procedure.
^ Carry out the evaporative emissions canister leak test. Evaporative Emission System Leak Test
^ Carry out the evaporative emission repair verification drive cycle. Evaporative Emission Repair Verification Drive Cycle

NOTE:
^ Inspect and install new O-ring seals as necessary.
^ Lubricate all O-ring seals with MERPOL(R) O-ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144-B.