Cruise Control Servo Cable: Service and Repair

REMOVAL







1. Remove the nut, bolt and the accelerator control splash shield.







2. Disconnect the speed control cable.
1 Disconnect the speed control cable end from the throttle nail head.
2 Depress the tabs and separate the speed control cable from the intake manifold.







3. Remove the speed control servo from the inner fender.
1 Disconnect the electrical connector.
2 Remove the speed control servo bracket mounting bolts.







4. Depress the locking tab and rotate the speed control cable cap to remove.







5. Remove the speed control cable.
1 Gently push the retaining spring.
2 Disconnect the speed control cable slug from the speed control servo pulley.

INSTALLATION







1. To install, reverse the removal procedure.

NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.